Circuit of the Americas track map for wall hanging! Austin, Texas This track is BIG, 36 inches (914mm) across! Track outline is 3/4 inch (19mm) wide, 1/2 inch (12mm) tall. It would look awesome on your garage (or living room) wall! 3d printed in gloss black PLA plastic, smooth beveled edges, finish line detail, and exterior pinstriping details make it stand out. This is the ideal size to hang on your wall, big enough to get noticed but small enough that it can be paired with other tracks to really make your garage look awesome! Hangs on your wall using your supplied double sided tape, 3m command strips, or simply hang from nails or screws. Or even drill thru it on center and screw it to the wall (best method if you want to add your own standoffs). Recommend minimum of 6x mounting points evenly spaced around the track to support it. LED backglow & wall standoff upgrade kit now available! https://www.ebay.com/itm/304776422882 3d printed, and as such may have minor imperfections that don’t affect how it looks and are only noticeable up close. Can be smoothed, filled, or painted if desired, but it doesn’t need it to look awesome! Printed in pieces (11x, with assembly letters) due to the large size, which fit like puzzle pieces and simply snap together (very firmly) for a permanent assembly. Instructions: 1. Do not fit pieces together until you are sure you want them together! 2. Arrange pieces in alphabetic order, to make the track shape shown. (Ref. last photo) 3. Press connections together by hand as you would with puzzle pieces on a hard surface like a table or floor (this will take some force). Sometimes trying one on top of the other will work better than the other way around. 4. Any connections that are not fully engaged (flush with each other) may be tapped with a soft faced hammer or mallet while on a hard surface to bring them flush. 5. Take care handling assembled track, it will not appreciate being dropped! (ask me how I know…- I did not have good luck using sticky tack to mount the first prototype) 6. Hang on the wall using double sided foam tape, 3m command strips, screws, nails.. etc. Hang from at least 4 evenly spaced points to spread out the weight. 7. Enjoy, it looks awesome!