ALL DECALS ARE MADE TO ORDER AND IS BRAND NEW USING PREMIUM VINYL. ALL ORDERS PLACED WITHIN BUSINESS DAYS WILL RECEIVE TRACKING NUMBER WITHIN 24 HOURS! EACH ORDER WILL COME IN THE SIZE YOU CHOOSE. IF THE SIZE YOU CHOOSE SAYS «(2 DECALS) THEN YOU WILL RECEIVE 2 DECALS. IF THE SIZE YOU CHOOSE SAYS «(1 DECAL Only)» THEN THAT ORDER WILL COME WITH ONLY 1 DECAL. **IMPORTANT**PLEASE MEASURE YOUR APPLICATION TO ENSURE THE SIZE YOU NEED. WE ARE NOT RESPONSIBLE IF THESE DECALS DO NOT FIT YOUR APPLICATION. CUSTOM SIZE IS AVAILABLE UPON REQUEST! Decorate your: laptops, Walls, Car, Windows, Bumpers, guitars, iPad, iPhone, refrigerator just about any flat smooth clean surface! About Vinyl Decals: These are DIE-CUT decals using premium material for outdoor heat and indoor use! Vinyl Decals come in 1 piece: 1. Top layer is a transparent transfer tape. (Holds your decal or sticker together until it is applied) 2. Middle layer is your actual decal or sticker (It is sandwiched between the Application Tape and the Wax Backing) 3. Bottom layer is the paper backing. (protects the adhesive until the decal is ready to be applied) Application Tips: 1. Do not apply on extreme cold or hot Surfaces. Ideal temperature must be between 60°F & 90°F (room temperature). 2. Do not touch the adhesive backing, oils from your skin will prevent sticking. 3. Before applying decal make sure there is no wax, oily products or dust on the surface of vehicle. Application Instructions: 1. Rub the sticker to be sure the transfer tape is properly adhered to the sticker. 2. Clean and dry the desired area. 3. Remove the paper backing slowly making sure the sticker stays adhered to the transparent transfer tape.4. Spray the area with 2% soap and 98% water. 5. Carefully position the sticker to the desired area. The water will allow the vinyl to be re-positioned. 6. Use a squeegee/credit card and rub the sticker from one side to the other, eliminating any air bubbles and water that is trapped underneath. Continue until the adhesive adheres to the vehicles surface. 7. Slowly remove the transfer tape, making sure no part of the sticker remains on the transfer tape. 8. You may use blow dryer to soften the adhesive some more and rub the sticker so it will adhere better. 9. Check for air bubbles. In most cases air bubbles can be worked to the edge of the sticker, but if not, a pin hole will allow the air out and become virtually invisible.10. Wrap the vinyl around the edges and use a blow dryer to dry off the remaining excess water.